Eppendorf 3100 Digital Water Bath Shake - Manual (Page 22)

16
4 4 O O
P PE ER RA AT TIIO ON N
4.1 Starting the Innova 3100
To initially start the instrument, press the ON/OFF switch (located on the right side of
the shaker) to the ON position.

NOTE:
The LED display will flash to indicate that the shaker has been off or the
power to the shaker has been interrupted. To stop the flashing display,
press any key.
Press the SELECT key until the RPM indicator lights. If the shaker is running, the
LED display will track the speed as it accelerates to the last entered speed setpoint.
The shaking action may be stopped or started by pressing the START/STOP key.
4.2 Continuous (Unlimited) Run
To set up a continuous run:
1. If the LED displays “Off”, press the START/STOP key.
2. Press SELECT until RPM is lit.
3. Press either
∆ or ∇ key to enter SET mode (SET indicator will light).
4. Set the speed by using the
∆ or ∇ key until the desired setpoint is displayed.

NOTE:
Holding the
∆ or ∇ key down will cause the setting to change more
rapidly.
The setpoint may be changed during a run without stopping the shaker by following
steps 2-4 above. During speed changes, the alarm may sound until the speed returns to
within 5 RPM of the setpoint; do not be concerned.