Eppendorf 3100 Digital Water Bath Shake - Manual (Page 16)

10
3 3 II
N NS ST TA AL LL LA AT TIIO ON N
& & S S
E ET T
--U U
P P
The Innova 3100 is a versatile instrument that can be operated in a
continuous fashion or set for a timed run. The following section
describes set up and installation procedures.
3.1 Unpacking & Inspection
Upon unpacking the unit, inspect it carefully for any apparent damage which may have
occurred during transit. Report any damage to the carrier and to the New Brunswick
Service Department (in the USA, call 1-800-631-5417) or to your New Brunswick
Service Representative. Do not discard the crate or packing material.
3.2 Voltage Configuration
Determine the voltage of your unit by checking the voltage selector and label on the
rear of the unit. Confirm that the correct electrical service package is included with
the unit by comparing the part number on the electrical service package to the
following table (also see Chapter 5).
In addition to checking the voltage of your unit as indicated in the WARNING above,
be sure to confirm that the correct electrical service package is included with the unit.
Compare the part number on the electrical service package to the following table:
WARNING!
It is critical that you check the voltage settings before
you plug the unit into a power source.
Confirm that the Voltage setting is correct by checking
the voltage setting on the Voltage Selector Switch and
the CAUTION label located over the power cord
connection (see Figure 2).