Eppendorf 3100 Digital Water Bath Shake - Manual (Page 20)

14

NOTE:
If you are using tap water as coolant for the unit, it is preferable that the
supply hose be attached to a supply valve, to minimize water use.
3.3.3 Platform Installation
A platform must be installed on the unit prior to use. To install the platform:
1. Make sure the circuit breaker on the right side of the unit is set to the OFF
position.
2. Make sure the mains/power cord is unplugged.
3. Place platform assembly on top of the drive arms (see Figure 7 on next
page).
4. Install each of the four locking knobs, through the support, into drive arms.
5. Tighten all four locking knobs.
WARNING!
Make sure shaker is unplugged from the mains/power
before installing platform.