Advance Adapters 713090 - Manual (Page 2)

ADVANCE ADAPTERS INC. P/N: 713090
P.O. Box 247, 4320 Aerotech Center Way New Item: (08/02)
Paso Robles, CA 93447 PAGE 2 OF 4
Telephone: (800) 350-2223 Fax: (805) 238-4201 Page Rev. Date: 08-14-01
SPECIAL NOTE: The components packaged in this kit have been assembled and machined for specific type of conversions. Modifications to any of the components will void
any possible warranty or return privileges. If you do not fully understand modifications or changes that will be required to complete your conversion, we strongly recommend that
you contact our sales department for more information. This instruction sheet is only to be used for the assembly of Advance Adapter components. We recommend that a service
manual pertaining to your vehicle be obtained for specific torque values, wiring diagrams and other related equipment. These manuals are normally available at automotive dealerships
and parts stores.
CHEVY V8 TO JEEP TJ BOLT-IN MOUNTS
REPLACING THE STOCK 4 CYL.
Install the new Chevy rubber mounts onto the engine block and install the saddle mount. As you set the Chevy block into the TJ frame
rails, you'll notice that you will have a couple of mounting options. The new mounts allow for some adjustments with the final engine
placement, side-to-side and front-to-back. Things to consider: the powertrain offset when locating the engine, and choice of the hole
locations which suits your particular application (transmission choice). When the final engine location is determined, tighten all bolts
accordingly.
Driver's side and
passenger side saddle
mount-to-frame mount.
Headers will require firewall modifications in the furthest back set of holes, but work great in the forward set of holes. Passenger side
header may require some clearance with certain starters (on solenoid housing). A heat shield and/or a mini hi-torque starter is
recommended.
Driver's side firewall-to-tunnel
seam should be trimmed or bent
over to provide transmission and
exhaust clearance. Passenger side firewall-to-tunnel
seam should be trimmed or bent
over to provide transmission and
exhaust clearance.
P/N 717090 driver's
side header installed
with mount in furthest
rearward location. P/N 717090 passenger
side header installed
with mount in furthest
foreward location.