beautypg.com

Advance Adapters 477021 User Manual

Page 13

background image

(Step A-35)

(35) Install the two lubrication tubes into the case. Note the

orientation shown in the photo above.

(Step A-36)

(36) Apply a very thin coat of silicone gasket sealant to the rear

case gasket, and position the rear case. Apply Loctite 242
to the threads and install the 10 bolts that retain the case
with a 14mm socket

loosely

. You will tighten these later,

after the centering of the case is performed in the following
procedures.

(Step A-33)

(33) Install the drive gear for the speedometer onto the output

shaft. Make sure the orientation is correct. The hardened
side goes against the bearing.

(Step A-34)

(34) Install the ball bearing onto the pocket on the output shaft

using a drop of assembly lube to hold it in place. Install the
oil pump drive gear.

(Step A-29)

(29) Install the shift fork and shift hub sleeve onto the output

shaft.

(Step A-31)

(31) Install the clutch hub onto the output shaft.

(Step A-32)

(32) Install the bearing onto the output shaft.

(Step A-30)

(30) Install the roll pin that holds the front wheel drive shift fork

in place.