beautypg.com

Advance Adapters 477021 User Manual

Page 12

background image

(Step A-27)

(27) Install the transfer gear onto the output shaft. Use assem-

bly lube!

(Step A-24)

(24) Install the small ball bearing in the machined pocket on the

output shaft. Use a drop of assembly lube to hold it in place.

(Step A-25)

(25) Install the spacer onto the output shaft.

(Step A-26)

(26) Install the 2 caged needle roller bearings on the output

shaft. Use assembly lube.

(Step A-21)

(21) Notice that the cluster / counter gear does not incorporate

the stock sub-gear and spring washer. These are not used!

(Step A-22)

(22) Install the detent plugs (with Loctite 242), spring and ball

assembly on both sides of the assembly cases. This will
position the shift rails once the retaining plugs are in-
stalled. Torque the detent plugs to 9 ft./lbs. Use assembly
lube!

(Step A-28)

(28) Before proceeding, make sure you have installed these

snap rings!

(Step A-23)

(23) Apply a drop of assembly lube on the tip of the 4WD indicator

switch and install it into its original position on the reduction
case.