beautypg.com

Tx2 crawler adapter toyota 4wd trucks 23t input – Advance Adapters 50-5906D User Manual

Page 4

background image

(13) With the screw plugs removed, the shift ball and spring

assemblies can be removed from both sides.

(14) Drive the roll pin out that

retains the high/low shift
fork using a 3/16" (4mm)
punch. Occasionally the
pin will fall into the case.
Don't worry. You will be
able to retrieve the pin
later. On 1979-83 and
1985-88 fuel injected
model transfer cases,

DO NOT REMOVE

roll

pin.

(11) Remove the thick spacer found behind the front wheel drive

gear and be aware of the small ball bearing underneath it.

(12) Use a 12mm socket to remove the four bolts that retain the

shift fork cover. With a 6mm Allen wrench, remove the shift
detent screw plugs found on both sides of the case.

(15) Remove the shift

rails, being careful
not to lose the inter-
lock pin that might
fall out.

(16) Remove the 4WD in-

dicator switch with a
22mm or adjustable
wrench.

This interlock pin is lo-
cated between the two
shift rail detent assem-
bly chambers.

ADVANCE ADAPTERS INC.

P/N: 50-5906D

P.O. Box 247, 4320 Aerotech Center Way
Paso Robles, CA 93447

PAGE 4 OF 9

Telephone: (800) 350-2223

Fax: (805) 238-4201

Page Rev. Date:

08-10-09

SPECIAL NOTE:

The components packaged in this kit have been assembled and machined for specific type of conversions. Modifications to any of the

components will void any possible warranty or return privileges. If you do not fully understand modifications or changes that will be required to complete your conversion,

we strongly recommend that you contact our sales department for more information. This instruction sheet is only to be used for the assembly of Advance Adapter

components. We recommend that a service manual pertaining to your vehicle be obtained for specific torque values, wiring diagrams and other related equipment.

These manuals are normally available at automotive dealerships and parts stores.

TX2 CRAWLER ADAPTER

TOYOTA 4WD TRUCKS 23T INPUT