beautypg.com

Tx2 crawler adapter toyota 4wd trucks 23t input – Advance Adapters 50-5906D User Manual

Page 3

background image

(6) Remove the 10 bolts retaining the rear case cover with a

14mm socket.

(5) Remove outer bearing C-clip by reaching inside case and

pushing up on gear, while lightly tapping on the case with
a plastic soft blow mallet.

(7) Pull case off. Remove the two lubrication tubes located on

either side of the main shaft.

Note their orientation!

(8) Using a 3/16" (4mm) punch, drive the roll pin out that

holds the front wheel drive shift fork.

(9) Slide the fork and clutch sleeve off the shift rail.

(10) Remove the front wheel drive gear and it's caged

needle roller bearing assembly.

ADVANCE ADAPTERS INC.

P/N: 50-5906D

P.O. Box 247, 4320 Aerotech Center Way
Paso Robles, CA 93447

PAGE 3 OF 9

Telephone: (800) 350-2223

Fax: (805) 238-4201

Page Rev. Date:

08-10-09

SPECIAL NOTE:

The components packaged in this kit have been assembled and machined for specific type of conversions. Modifications to any of the

components will void any possible warranty or return privileges. If you do not fully understand modifications or changes that will be required to complete your conversion,

we strongly recommend that you contact our sales department for more information. This instruction sheet is only to be used for the assembly of Advance Adapter

components. We recommend that a service manual pertaining to your vehicle be obtained for specific torque values, wiring diagrams and other related equipment.

These manuals are normally available at automotive dealerships and parts stores.

TX2 CRAWLER ADAPTER

TOYOTA 4WD TRUCKS 23T INPUT