Tx2 crawler adapter toyota 4wd trucks 23t input, Disassembly procedures – Advance Adapters 50-5906D User Manual
Page 2

(1)
The transfer case must be in 2WD High before
starting the disassembly procedures.
Remove the
nut with a 30mm socket and then remove the flange.
(2) Remove the 7 bolts that retain the rear extension housing
with a 14mm metric socket.
(3) With the rear extension housing removed, you will see
the oil pump and speedometer drive gears. Slide the
gears off of the rear output shaft.
(4) Remove the rear output shaft bearing.
DISASSEMBLY PROCEDURES
The Advance Adapters TX2 crawler kit is ideal for the avid Toyota Truck rock crawler. The installation of the TX2 requires you to
almost completely disassemble the donor transfer case. We have provided illustrative disassembly and assembly instruc-
tions to assist you. These instructions are to be used as a guide. The official Toyota shop manual is strongly recommended
for additional information.
ADVANCE ADAPTERS INC.
P/N: 50-5906D
P.O. Box 247, 4320 Aerotech Center Way
Paso Robles, CA 93447
PAGE 2 OF 9
Telephone: (800) 350-2223
Fax: (805) 238-4201
Page Rev. Date:
08-10-09
SPECIAL NOTE:
The components packaged in this kit have been assembled and machined for specific type of conversions. Modifications to any of the
components will void any possible warranty or return privileges. If you do not fully understand modifications or changes that will be required to complete your conversion,
we strongly recommend that you contact our sales department for more information. This instruction sheet is only to be used for the assembly of Advance Adapter
components. We recommend that a service manual pertaining to your vehicle be obtained for specific torque values, wiring diagrams and other related equipment.
These manuals are normally available at automotive dealerships and parts stores.
TX2 CRAWLER ADAPTER
TOYOTA 4WD TRUCKS 23T INPUT