Advance Adapters 50-3032A User Manual
Page 6
Speedometer Calibration:
There are two factors that affect your speedometer reading; actual tire diameter and axle gear
ratio. The actual tire diameter is usually different than what is printed on the side wall of your tire. For example: A 33 x 11.5
x 15 tire (depending on the brand), may actually measure 32.5" in diameter. Tire sizes vary greatly among the suppliers. Even
the same tire from the same manufacturer can vary as much as 7% in diameter.
ADVERTISED TIRE DIAMETER
37"
36"
35"
33"
32"
31"
30"
29" 28"
5.13
36T
37T
4.88
34T
35T
39T
41T
GEAR
4.56
32T
33T
35T
36T
37T
37T
38T
RATIO
4.10
29T
30T
33T
34T
35T
36T
37T
38T
39T
3.73
26T
27T
31T
32T
32T
33T
34T
34T
35T
3.55
30T
31T
31T
32T
33T
33T
34T
3.07
26T
26T
27T
27T
28T
28T
29T
53001-492 (29T)
53001-488 (41T)
2538-936 (36T)
J3212-730 (30T)
J3212-731 (31T)
J3212-733 (33T)
J3212-734 (34T)
J3212-735 (35T)
J3212-221 (39T)
J3212-222 (40T)
Listed below are a few of the part numbers for the Jeep speedometer pinion gears to calibrate your speedometer.
ADVANCE ADAPTERS INC.
P/N: 50-3032A
P.O. Box 247, 4320 Aerotech Center Way
New Item: (01/02)
Paso Robles, CA 93447
PAGE 6 OF 6
Telephone: (800) 350-2223
Fax: (805) 238-4201
Page Rev. Date:
04-24-02
DANA 300 T/C
32 SPLINE OUTPUT WITHOUT YOKE
SPECIAL NOTE:
The components packaged in this kit have been assembled and machined for specific type of conversions. Modifications to any of the
components will void any possible warranty or return privileges. If you do not fully understand modifications or changes that will be required to complete your conversion,
we strongly recommend that you contact our sales department for more information. This instruction sheet is only to be used for the assembly of Advance Adapter
components. We recommend that a service manual pertaining to your vehicle be obtained for specific torque values, wiring diagrams and other related equipment.
These manuals are normally available at automotive dealerships and parts stores.