Advance Adapters 50-3032A User Manual
Page 3
ADVANCE ADAPTERS INC.
P/N: 50-3032A
P.O. Box 247, 4320 Aerotech Center Way
New Item: (01/02)
Paso Robles, CA 93447
PAGE 3 OF 6
Telephone: (800) 350-2223
Fax: (805) 238-4201
Page Rev. Date:
01-17-02
SPECIAL NOTE:
The components packaged in this kit have been assembled and machined for specific type of conversions. Modifications to any of the components will
void any possible warranty or return privileges. If you do not fully understand modifications or changes that will be required to complete your conversion, we strongly recommend
that you contact our sales department for more information. This instruction sheet is only to be used for the assembly of Advance Adapter components. We recommend that a
service manual pertaining to your vehicle be obtained for specific torque values, wiring diagrams and other related equipment. These manuals are normally available at automotive
dealerships and parts stores.
DANA 300 T/C
32 SPLINE OUTPUT WITHOUT YOKE
ASSEMBLY INSTRUCTIONS:
1.
Remove the new shaft from our tailhousing assembly. Be sure to retain the shim race to set the proper end play. The
pocket bearing should be checked on our new shaft to verify that it has been installed.
2.
Install the shaft through the front
of the transfer case, through the
slider hub, and onto the stock gear.
You should make sure you lube the
surface between the gear and shaft.
Install the modified thrust washer
onto the output shaft. This thrust
washer is required to obtain proper
gear and slider alignment with the
other components in the transfer case.
3.
Once the gear, shaft, and
thrust washer are in place,
install the tapered bearing
onto the shaft. This should
be a light press fit.