Advance Adapters 50-9001 - Manual (Page 2)

ADVANCE ADAPTERS INC. P/N: 50-9001
P.O. Box 247, 4320 Aerotech Center Way New Item: (9/09)
Paso Robles, CA 93447 PAGE
Telephone: (800) 350-2223 Fax: (805) 238-4201 Page Rev. Date:
SPECIAL NOTE: The components packaged in this kit have been assembled and machined for specific type of conversions. Modifications to any of the components will
void any possible warranty or return privileges. If you do not fully understand modifications or changes that will be required to complete your conversion, we strongly recommend
that you contact our sales department for more information. This instruction sheet is only to be used for the assembly of Advance Adapter components. We recommend that a
service manual pertaining to your vehicle be obtained for specific torque values, wiring diagrams and other related equipment. These manuals are normally available at automotive
dealerships and parts stores.
2 OF 6
Introduction:
This adapter kit fits Land Rover series I ,II,IIA and III transfer cases and adapts them to a circular 6 pattern. This
adapter allows the series Land Rover owner the opportunity to repower and install different transmissions to the very
durable and strong "series" transfer case. This adapter is to be used in conjunction with either one of our “Dana 300”
style adapters or on some applications it can be bolted directly to a stock transmission tail housing. We have designed
the adapter kit to retain the PTO function on the stock transfer case.
Preparation For Assembly:
Follow the service manual procedure to remove the transfer case from the transmission. Thoroughly inspect the
tranfer case to determine the condition. Overhaul if necessary to insure the quality of your adapter installation.
Procedure:
1. Install the drive gear onto the new spud shaft with spacer 716239 behind the drive gear. Then install the original
flat washer and the supplied lock tab. Press the gear fully onto the shaft and test fit the lock washer. The
tangs will need to be trimmed. These parts are retained because they provide lubrication to the splines of the
shaft and input gear. Use locking compound on the new lock nut and torque to 75ft.lbs.
LAND ROVER SERIES T-CASE to NP
CIRCULAR 6 ADAPTER with DODGE 29 SPLINE
03-25-10