Advance Adapters 712568 - Manual (Page 7)

(2) HOLES TO BE ELONGATED
AS SHOWN
LOWER SECTION OF TWO PIECE DUST COVER
TYPE 2
TYPE 1
THERE ARE VARIOUS TYPES OF DUST
COVERS FOR THE JEEP MOTORS.
WHEN YOU HAVE FOUND OR HAVE THE
PROPER DUST COVER, YOU WILL NEED
TO MODIFY IT ACCORDINGLY. CUT
OUT THIS AREA FOR SLAVE CYLINDER
CLEARANCE BEFORE ASSEMBLING
THE BELLHOUSING TO THE MOTOR.
FAILURE TO DO SO, WILL RESULT IN
DISASSEMBLY OF BELLHOUSING TO
MOTOR.
ADVANCE ADAPTERS INC. P/N: 712568
P.O. Box 247, 4320 Aerotech Center Way
Paso Robles, CA 93447
PAGE 7 OF 8
Telephone: (800) 350-2223 Fax: (805) 238-4201 Page Rev. Date: 04-09-96
SPECIAL NOTE: The components packaged in this kit have been assembled and machined for specific type of conversions. Modifications to any of the components
will void any possible warranty or return privileges. If you do not fully understand modifications or changes that will be required to complete your conversion, we strongly
recommend that you contact our sales department for more information. This instruction sheet is only to be used for the assembly of Advance Adapter components.
We recommend that a service manual pertaining to your vehicle be obtained for specific torque values, wiring diagrams and other related equipment. These manuals are
normally available at automotive dealerships and parts stores.
*NOTE: THE LOWER DUST COVER MUST BE MODIFIED
ACCORDINGLY BEFORE INSTALLATION OF SLAVE CYLIN-
DER. SLAVE CYLINDER SHOULD BE INSTALLED TO TOP OF
DUST COVER.
BELLHSG. FOR JEEP 4.0 & V8 304 ENG.
TO 1996 & NEWER GM NV4500