beautypg.com

Snorkel TB85J CE User Manual

Page 65

background image

Chapter 11 – Troubleshooting

TB80/TB85J – 0112622EE

61

Symptom

Drive functions do not work.

Can not reach maximum drive

speed of 4.8 km/h (3 mph).

Wheels will not turn when winch-

ing.

Steer wheels do not turn when the

drive joystick is moved to the right

or to the left.

Steer wheels do not turn right or

left – machines with tow option.

Tilt alarm does not work.

Circuit breaker will not reset.

Electrical outlet does not work.

Improper AC generator output

voltage.

Hydraulic fluid temperature 93°C

(200°F) or more.

Severe hydraulic leak.

Possible Cause

Platform overload sensor is tripped.

Booms are not retracted and lowered.

Drive range switch is in LO.

High range speed selector knob is

in the low speed position (down) –

four wheel drive machines only.

Drive hubs are engaged.

The drive joystick must be in the for-

ward or reverse position for the steer-

ing wheels to turn.

Tow kit steering float valve is open.

Booms are stowed.

Electrical circuit has not had time to

cool.

Electrical system malfunction.

Power supply not plugged in.

Machine/generator switch not in the

generator position.

Hydraulic oil is cold and thick.

Prolonged boom operation or driving.

High pressure fluid return to reser-

voir caused by kinked or twisted

hose.

Hydraulic system component failure.

Failure of hose, tube, fitting, seal,

etc.

Corrective Action

If horn is sounding and red overload

light is on or blinking, remove weight

from the platform until the load is at

or below rated capacity.

Fully retract and lower the boom.

Place the switch in the HI position.

Place the knob in the high speed

position (up).

Turn drive wheel disconnect plates

around so nipples point inward.

Push the drive joystick slightly for-

ward or backward when operating

steer right or left.

Close the steering float valve.

Normal operation. The tilt alarm is op-

erational when the booms are near

horizontal.

Wait a minute or two for circuit to

cool, then push circuit breaker but-

ton in to reset.

Do not operate machine until repairs

are made.

Plug the power cord into the power-

input connector on the generator.

With engine running, place the ma-

chine/generator switch in the genera-

tor position.

Use cold weather hydraulic oil as rec-

ommended for weather conditions.

Warm oil before operating the ma-

chine.

Stop operation until fluid cools.

Remove the kink or twist from the

hose. Let fluid cool before operating.

Stow the machine and do not oper-

ate until repairs are made.

Do not operate machine until repairs

are made.

This manual is related to the following products: