beautypg.com

Danger, Warning – Snorkel TB85J CE User Manual

Page 49

background image

Chapter 8 – Operation

TB80/TB85J – 0112622EE

45

Figure 8.7 – Platform

3. Hold the appropriate control in the desired direction.

Always look in the direction of movement.

4. Releasing the control to its neutral position, or re-

leasing the foot switch will stop movement.

Platform Overload Sensing System

Boom and drive functions are stopped when the platform

load reaches or exceeds rated capacity. The horn will

sound intermittently and the red light (refer to Figure 8.6)

will illuminate when the platform rated work load is ex-

ceeded.

The horn will sound and the light will flash until the ex-

cess load is removed from the platform. At that time, the

boom and drive functions are again operational.

If the overload exceeds rated platform capacity by more

than 20 percent, the system will error out, stopping all

boom and drive functions. The horn will then sound con-

tinuously and the red light will stay illuminated at the

upper and lower controls (refer to Figure 8.2).

The horn will sound and the light will stay on until the

excess load is removed from the platform and the start

switch is turned off and back on, resetting the system.

At that time, the boom and drive functions are opera-

tional.

A

Danger

The aerial platform can tip over if it becomes un-

stable. Death or serious injury will result from a tip-

over accident. Do not exceed the capacity values

indicated on the platform rating placard.

The overload sensing system is not active when the ma-

chine is being driven with the main boom below horizon-

tal and fully retracted. This allows the machine to be driven

without the system sensing an overload due to rough

ground conditions.

To eliminate repeated tripping of the system during ma-

chine operation, there is a five second delay in machine

functions following:

• starting the engine.

• placing the drive/boom selector switch in the boom

position when the main boom is below horizontal and

fully retracted.

• removing excess load from the platform.

Driving and Steering

A

Danger

The aerial platform can tip over if it becomes un-

stable. Death or serious injury can result from a tip-

over accident. Do not drive an elevated aerial plat-

form on soft, uneven, or sloping surfaces. Do not

drive four wheel drive machines on grades that ex-

ceed 30 percent or two wheel drive machines on

grades that exceed 25 percent.

For operation of four wheel drive machines on grades up

to 30 percent, or two wheel drive machines on grades up

to 25 percent, it is recommended that the main boom be

near horizontal and the jib on TB85J machines elevated

just enough to provide adequate ground clearance.

A 30 percent grade is a 0.91 m (36

″) vertical rise in 3.05

m (10

′) horizontal length.

A 25 percent grade is a 0.76 m (30

″) vertical rise in 3.05

m (10

′) horizontal length.

Avoid driving with the platform over the front (steer) end of

the chassis. In this position the machine is difficult to

control because:

• drive and steer control movements and their result-

ing machine movements are reversed.

• when driving fast, sudden turns or stops produce more

severe reactions to platform occupants.

• more turning space is required to prevent the plat-

form from colliding with obstacles several feet be-

yond the path of the tires.

A

Warning

Death or serious injury can result from improperly

driving or steering the aerial platform. Read and

understand the information in this manual and on

the placards and decals on the machine before op-

erating the aerial platform on the job.

The blue and yellow arrows on the chassis indicate the

direction the chassis will move when the drive or steer

control is moved toward the corresponding color.

Lanyard

Anchors

Platform Foot

Switch

This manual is related to the following products: