Snorkel MHP34J(Bi-Energy Option) - Manual (Page 17)

2. Safety Devices
■ Safety Device Information
For emergency operation controls and procedures,
see the “Emergency Operation” chapter 9, in this
manual.
The devices listed in this chapter are safety de-
vices.
They are on the MHP12/34J to increase safety in
the work place for both the operator and other peo-
ple near the MHP12/34J.
DO NOT by pass, disable, modify, or ignore
any of these devices. Check them carefully at
the start of each work shift to see that they
are in working order (see “Daily Inspection
and Maintenance” chapter 7). If any is found
to be defective, remove the MHP12/34J from
service immediately until a qualified service
technician can make repairs.
■ Emergency Stop Switches
❑ At ground control box
Figure 2.1 - Emergency Stop Switch at
Ground Control Box
Press the EMERGENCY STOP switch cover down,
at any time, under any conditions and the entire
machine stops, and nothing moves. This emer-
gency stop switch cover must be up and the switch
turned on for anything on the MHP12/34J to work.
❑ At platform control box
Figure 2.2 - Emergency Stop Switch at
Platform Control Box
Press the EMERGENCY STOP switch cover down,
at any time, under any conditions and the entire
machine stops, and nothing moves. This emer-
gency stop switch cover must be up and the switch
turned on for anything on the MHP12/34J to work.
NOTE:
The ground control box is designed to override
the platform control box. If the platform control
box EMERGENCY STOP switch is down (off) the
ground control box can still be used to start and
operate the MHP12/34J.
■ Other Safety Devices
❑ Lanyard anchor points
Figure 2.3 - Lanyard Anchor Points
MHP12/34J – 11447A page 2 - 1
CAUTION