Snorkel AB60J - Manual (Page 43)

Chapter 7 – Prestart Inspection
AB60J – 0181972 39
If the power was on, repair or replace the re-
ceptacle.
All Motion Alarm
The machine may be equipped with an all motion
alarm.
Operate machine functions to ensure that the alarm
sounds to warn personnel in the area that the aerial
platform is in motion.
Air Line to Platform
The machine may be equipped with an optional air line
to the platform.
• Inspect the components, including the air line, mount-
ing hardware, and the caps on the input and output
connectors, etc. to verify all components are present
and are in working condition.
Driving and Platform Work Lights
The machine may be equipped with driving lights and/or
platform work lights.
• Turn the engine on and use the switch on the back
of each light to momentarily turn it on to see that it
works.
Tow Kit
The machine may be equipped with an optional tow kit.
• Inspect the components, including the tow bar, steer
arm, and chains, etc. to verify all components are
present and are in working condition.
Platform Glazier Package
To inspect the platform glazier package:
1. Inspect the glazier trays (refer to Figure 7.23) to make
sure they are in good condition and are not bent or
distorted.
2. Inspect the keeper pins to make sure they are in good
condition and are not bent or distorted.


Figure 7.23 – Platform
3. Make sure the straps and padding are in good condi-
tion and are not worn, cut or frayed.
Platform Control Cover
The machine may be equipped with an optional platform
control cover.
Inspect the cover to ensure it fits properly over the
control panel.
Placards and Decals
To inspect the placards and decals:
1. Inspect all safety and operational placards and de-
cals. Make certain they are in place, in good condi-
tion, and are legible.
2. Clean the placards and decals with soap and water,
and a soft cloth if the words or pictures cannot be
seen.
Caution
Solvents may contain hazardous ingredients. Follow
the manufacturer’s label for proper use and disposal.
Wear protective gloves and splash-proof safety
glasses when using solvents.
3. Remove wet paint overspray with a natural biode-
gradable solvent and a soft cloth.
4. Replace any missing, damaged, or illegible placards
or decals before operating the aerial platform.
Placard and decal kits are available from Snorkel.
The safety related placards and decals are illustrated on
the following pages.

Keeper Pins
Straps
Padding
Trays