Snorkel SPM20-sn00000 - Manual (Page 23)

19
SUCCESSFULLY COMPLETED THE SERVICE TRAINING FOR THE SPECIFIC
PRODUCT MODEL.
Table 2-1. Inspection and Maintenance Table
TYPE FREQUENCY PRIMERY
RESPONSIBILITY
SERVICE
QUALIFICATION
REFERENCE
Pre-Start
Inspection
Before using each day,
or whenever there’s an
Operator change. User or Operator Operator and Safety
Manual
Pre-Delivery
Inspection
(See Note) Before each sale, lease,
or rental delivery. Owner, Dealer, or
User
Qualified
Mechanic
Service and
Maintenance
Manual and applicable
Inspection form
Frequent
Inspection
In service for 3 months
or 150 hours, whichever
comes first; or; Out of
service for a period of
more than 3 months; or
Purchased used. Owner, Dealer, or
User
Qualified
Mechanic
Service and
Maintenance
Manual and applicable
Inspection form
Annual
Machine
Inspection Annually, no later than 13
months from the date of
prior inspection. Owner, Dealer, or
User
Qualified
Mechanic
Service and
Maintenance
Manual and applicable
Inspection form
Preventative
Maintenance
At intervals as specified
in the Service and
Maintenance Manual. Owner, Dealer, or
User
Qualified
Mechanic
Service and
Maintenance
Inspection form
NOTE: Inspection forms are available from the manufacture. Use the Service and Maintenance Manual to
perform inspections.
2.3 PRE-START INSPECTION
The Pre-Start Inspection should include each of the following:
1. Cleanliness – Check all surfaces for leakage (oil, fuel, or battery fluid) or foreign objects.
Report any leakage to the proper maintenance personnel.
2. Decals and Placards – Check all for cleanliness and legibility. Make sure no decals or
placards are missing. Make sure all illegible decals and placards are cleaned or replaced.
3. Operators and Safety Manuals – Make sure a copy of the Operation and Safety Manual,
Safety Manual, and Manual of Responsibilities is enclosed.
4. Daily Walk - Around Inspection – (See Section 2.4)
5. Battery – Charge as required.
6. Hydraulic Oil – Check the hydraulic oil level.
NOTE: Check Service Manual for instructions and hydraulic oil specification before adding.
DO NOT OVERFILL.