Snorkel SPM20-sn00000 - Manual (Page 15)

11
Tipping Hazard
• The user should be familiar with the surface before driving. Do not exceed the allowable
side slope and grade while driving.
• Do not elevate platform or drive with platform elevated while on a slope, or on an uneven
or soft surface.
• Before driving on floors, bridges, trucks, and other surfaces, check allowable capacity of
the surfaces.
• Never exceed the maximum platform capacity. Distribute loads evenly on platform floor.
• Keep the chassis of the machine a minimum of 2 ft. (0.6m) from holes, bumps, drop-offs,
obstructions, debris, concealed holes, and other potential hazards at the ground level.
• Never attempt to use the machine as a crane. Do not tie-off machine to any adjacent
structure.
• Do not increase the platform size with unauthorized deck extensions or attachments,
increasing the area exposed to wind will decrease stability.
• If mast assembly or platform is caught so that one or more wheels are off the ground,
the operator must be removed before attempting to free the machine. Use cranes, forklift
trucks, or other appropriate equipment to stabilize machine and remove personnel.
Crushing And Collision Hazard
• Personal protection equipment must be worn by all operating and ground personnel.
• Check work area clearances above, on sides, and bottom of platform while driving and
lifting or lowering platform
• During operation, keep all body parts inside platform railing.
• Always post a lookout when driving in areas where vision is obstructed.
• Keep non-operating personnel at least 6 ft. (1.8m) away from machine during all driving
operations.
• Limit travel speed according to conditions of ground surface, congestion, visibility, slope,
location of personnel, and other factors causing hazards of collision or injury to personnel.
• Be aware of stopping distances in restricted or close quarters or when driving in reverse.