Apple Using WaveBurner Logic Pro 7.1 - Manual (Page 42)

42
The WaveBurner AU Manager allows you to disable Audio Units plug-ins that you don’t
want to use in WaveBurner, even if they pass the test. Simply uncheck the
corresponding checkbox in the Use column to disable any plug-in. You can store your
choice of Audio Units plug-ins by clicking OK.
The results of the test are shown in the Compatibility column. Audio Units plug-ins that
“failed” the validation test, can be enabled—but be aware that these plug-ins can
cause problems. Use of plug-ins that have failed the validation can negatively affect the
test results of subsequently scanned plug-ins, can cause WaveBurner crashes or even
lead to data loss (destroyed project files).
We strongly recommend that you check the manufacturer’s website for updated
versions of Audio Units plug-ins that fail the validation.
Note: If you press Shift-Control while launching WaveBurner, the AU Safe Mode will be
used: Only plug-ins that pass the validation test will be used; manually activated plug-
ins that failed the validation test will not be available.
Click “Reset & Rescan All” to run another validation test, after installing plug-ins/
updaters or moving components in the Finder, while WaveBurner or the AU Manager
are open. You can also rescan individual plug-ins—in cases where you’ve installed an
updated version. Updated plug-in versions will automatically be tested the next time
WaveBurner is launched. They will be enabled automatically, if they pass the test.
Adding and Deleting Plug-Ins
You add plug-ins to selected regions in the Region Plug-Ins list, and add plug-ins to the
overall project in the Mix Plug-Ins list.
To add a plug-in to a region:
1 Click the Region Plug-Ins tab to show the Region Plug-Ins list.
2 In the Region list, click the target region that you want to add the plug-in to.
3 Choose the category of plug-in you want to add from the Add Plug-In pop-up menu,
then choose the plug-in from the submenu.
The plug-in appears in the Region Plug-Ins list, below any plug-ins already added to
the region.
To add a plug-in to the overall project:
1 Click the Mix Plug-Ins tab to show the Mix Plug-Ins list.
2 Choose the category of plug-in you want to add from the Add Plug-In pop-up menu,
then choose the plug-in from the submenu.
The plug-in appears in the Mix Plug-Ins list, below any plug-ins already added to the
project.
If you no longer want to use a plug-in, you can delete it from the list.