Apple Setting Up Your Power Macintosh G4 (PCI & AGP) User Manual
Page 61
Telephone and Modem Information
61
Information You Need in Germany
Diese Modem-Karte ist als Endeinrichtung vorgesehen und muss an ein TAE mit F-Kodierung angeschlossen
werden.
Diese Endeinrichtung ist in Konformität gemäss Niederspannungsrichtlinie 73 / 23 / EWG sowie EMC-Richtlinien
89 / 336 / EWG und 92 / 31 / EWG.
Information You Need in France
Ce matériel est conforme aux normes applicables de sécurité éléctrique d’après la directive 73 / 23 / CEE et aux
normes applicables de comptabilité éléctromagnétique d’après la directive 89 / 336 / CEE, modifié par la directive
92 / 31 / CEE.
Information You Need in Australia
All telecommunications devices are required to be labelled as complying to the Australian telecommunications
standards, ensuring the health and safety of the operator and the integrity of the Australian telecommunications
network. To provide compliance with the Australian Communications Authority’s technical standards, please
ensure that the following AT commands are maintained:
m ATB0 (ITU/CCITT operation)
m AT&G0 (no guard tone)
m AT&P1 (33/66 pulse dial make/break ratio)
m ATS0 = 0 or ATS0 = 1 (no answer or answer greater than one ring)
m ATS6 = 95 (DTMF period between 70–255 ms)
m ATS11 = 95 (DTMF period between 70–255 ms)
For calls that are automatically generated, a total of three call attempts are allowed to a telephone number, with a
minimum period between calls of 2 seconds. If the call does not connect after three attempts, 30 minutes must
expire before automatic redialing may be initiated. Failure to set the modem (and any associated communications
software) to the above settings may result in the modem being non-compliant with Australian
telecommunications standards. Under these circumstances a user could be subject to significant penalties under
the Telecommunications Act 1997.
Warning
This card must be properly secured in order for you to use it. Telecommunications network voltages
exist inside the computer and the telecommunications line connection must be removed before opening the
computer.