Apple Setting Up Your Power Macintosh G4 (PCI & AGP) - Manual (Page 43)

Working Inside the Computer 43
m If you’re installing a second ATA drive in drive position 3:
m With the connectors facing you, attach the screws to the right side of the carrier.
m Insert and tighten the screws on the left side until the tab bends slightly inward.
m If you’re attaching a 1.0-inch drive to an empty carrier in drive position 3, insert the
screws through the bottom of the carrier.
m If you’re installing a 1.6-inch SCSI drive in the carrier, attach it with screws through the
carrier’s lower side holes, as shown on the right side of the illustration.
Note: The tinted screws illustrated below indicate the four screws that came in the
computer’s accessory kit. Use them where shown. Where untinted screws are shown, use
the screws that came with the new drive.
Attach an additional SCSI drive (1.6" high)
to the lower portion of the drive carrier
by screwing it into position on its sides. Attach an additional ATA drive (1" high)
to the upper portion of the drive carrier
by screwing it into position on its sides.
Attach the two screws on this side first.
These two
tabs will
bend
inward as
you tighten
these two
screws.
ATA or SCSI drives
that are 1" high are
attached to the lower
portion of the drive
carrier from the bottom.
Position the hard disk drive on the drive carrier so that the ribbon cable connector
and the power cord connector are accessible.