Apple Qmaster 3 - Manual (Page 40)

Batch Monitor [-clustername ] [-clusterid
address:port number>] [-jobid -batchid ] [-timeout
] [-query ] [-help]
To cancel a job or batch
µ
Use the following command:
Batch Monitor [-clustername ] [-clusterid
] -kill -jobid -batchid
Command Options
This table provides information about each of the command options for monitoring
batches.
Description Monitoring command option
Use to specify the name of the cluster to which the job was sent. -clustername
User password for the cluster specified by ID or name. -password
Optionally, you can use -clusterid to enter the cluster ID and
port number instead of using -clustername .
Or, if you used -clustername and the cluster requires a password,
use -clusterid to specify the user name and password. (You
need to include the IP address:port number as well whenever
you use -clusterid .)
Use Apple Qmaster -show or Compressor -show to see a
cluster’s IP address and port number.
-clusterid
name:password@IP
address:port number>
Use to specify the job you want to monitor.
When you use the -jobid option, you must also specify the
-batchid , in the form of the name that was given to the batch
when it was submitted. (The -batchid and -jobid are displayed
after a batch is submitted.)
If you do not use the -jobid option, all the jobs submitted to the
specified cluster are listed.
-jobid
-batchid
Use to specify the number of seconds before Batch Monitor can
quit when looking for a cluster. The default value is 0, which puts
no limit on the timeout and allows Batch Monitor to browse the
network for as long as it needs to find the cluster. -timeout
Use to specify how frequently, in seconds, the job status should be
updated. -query
Cancels the specified job or batch. -kill -jobid
-batchid
Displays information about supported options for Batch Monitor . -help
40 Chapter 1 Using Apple Qmaster 3