Class1 Vernier Throttle for CAT - Manual (Page 3)

3
DOC 101057C_c:\manuals\throttles\cats\catthrot.p65
Interlocks
NOTE: The interlock schemes shown in this manual are examples only and may not be suit-
able for specific applications. The throttle interface is active whenever power is applied.
Special Programming The ECM must be programmed for remote throttle operation and there
are several considerations including vehicle speed and max RPM that need to be configured.
Class1 provides a variety of engine controls that are used in a broad range
of applications, therefore it is impossible for Class1 to determine the suitabil-
ity of a particular control for any specific application. The flexibility of our
products allows them to be used in a limitless number of custom applications.
Class1 can advise you of the features that are available on a given product
so that you can determine what product will meet your needs. We believe
that the Original Equipment Manufacturer’s (OEM) engineering departments
should be qualified experts in their product field and are the authorities on
product application and safety. Since our products are typically used in safety
critical applications, the OEM must undertake appropriate testing to prevent
injury to the end user.
WARNING
!
IT IS THE PURCHASER’S RESPONSIBILITY TO DETERMINE
THE SUITABILITY OF ANY PRODUCT FOR AN INTENDED
APPLICATION, AND TO INSURE THAT IT IS INSTALLED
AND GUARDED IN ACCORDANCE WITH ALL APPLICABLE
FEDERAL, STATE, LOCAL AND NFPA SAFETY AND HEALTH
REGULATIONS, CODES AND STANDARDS.