Class1 Total System Manager - Manual (Page 6)

6
P
ROGRAMMING
Programming of the Total System Manager is accomplished using push-
button switches and a straightforward menu approach. A digital display and 4 LED’s
provide feedback to the programmer.
PROGRAM
SWITCH
This switch and the USER switch when held
until the display shows three (3) dashes (---)
puts the T.S.M. into the programming mode.
When held until (dEF) is displayed (aprox.
15 seconds), the factory defaults are pro-
grammed into the system.
The final programming step is to hold the
PROGRAM switch until (Pro) is displayed
to save the new values.
PROGRAM MENU SWITCHES
NEXT
SWITCH
Pressing this switch will cycle through each
output, the LED next to each output will light
when that output is selected and the digital
display will also indicate the load selected
(L01-L13).
MODE SWITCH
AND
LED’
S
The MODE switch toggles through the avail-
able modes for load management.
RESPONSE LED
Output is ON only when the
parking brake
IS NOT
set.
SCENE LED
Output is ON only when the
parking brake
IS
set.
BOTH LED
’
S
The output can be ON re
gardless of the parking brake
status.
ACTIVE SWITCH
AND
LED’
S
This toggles the switch source for the se-
lected output.
IGNITION LED
Output is tied to the ignition
switch.
WRN MASTER
Output is tied to the master
switch.
PRIORITY
SWITCH
This switch selects the sequence and shed
priority level for the selected output. A small
digital display shows the priorities (P00-P08)
as they cycle through. Loads sequence on
in 1-8 priority and shed off in 8-1 priority. Pri-
ority 0 loads never shed, but will sequence
on and off.
USER
This adjusts the setpoint voltage for output
#13 (term. 19).
Pressing this button increases the ‘trip’ point
in 0.1 volt increments from 10.5 VDC to 15.0
VDC.
NOTE
: If the setpoint is 13.8 volts or higher,
output #13 will activate when the system volt-
age rises to the setpoint. If the setpoint is
less than 13.8 volts, output #13 will activate
when the voltage falls to the setpoint.
STORE
SWITCH
The STORE switch saves the current con-
figuration for the selected output. The dis-
play will indicate that the values were saved
by showing three (3) dashes (---) and then
the load number (Lxx).
RESPONSE
SCENE
NEXT
STORE
MODE
PRIORITY USER DATA
PROGRAM
IGNITION
WRN MASTER
ACTIVE
PROGRAM MENU