Wire view of aem ems – AEM 30-6611 Series 2 Plug & Play EMS User Manual
Page 8
Page 8 of 13
Application Notes for EMS P/N 30-6611
KA24DE, GA16DE, SR20DE
Make:
Nissan/Infiniti
Description
Function
ECU Pin #
Model:
240SX, Sentra, 200SX, Altima, G20
Spare Injector Drivers:
Injector 5
29
Years Covered:
1996-1999
Spare Injector Drivers:
Injector 6
30
Engine Displacement:
1.6L, 2.0L, 2.4L
Spare Injector Drivers:
Injector 7
31
Engine Configuration:
Inline 4
Spare Injector Drivers:
Injector 8
32
Firing Order:
1-3-4-2
Spare Injector Drivers:
Injector 9
116
N/A, S/C or T/C:
N/A
Spare Injector Drivers:
Injector 10
117
Load Sensor Type:
MAF or MAP
Spare Coil Drivers:
Coil 2
58
MAP Min:
0.5 Volts
Spare Coil Drivers:
Coil 3
64
MAP Max:
4.5 Volts
Spare Coil Drivers:
Coil 4
36
MAF Min:
0.47 Volts
Boost Solenoid:
PW 2
34
MAF Max:
4.98 Volts
EGT 1 Location:
EGT 1
62
# Coils:
1 (Distributor)
EGT 2 Location:
EGT 2
65
Ignition driver type:
0-5V Falling Edge trigger
EGT 3 Location:
EGT 3
2
# of Injectors:
4 (Inj 1-4)
EGT 4 Location:
EGT 4
67
Factory Injectors:
185cc-250cc saturated
Spare 0-5V Channel:
MAP 66
Factory Inj Resistors:
No
Spare 0-5V Channel:
ADCR11 9
Injection Mode:
Sequential
Spare 0-5V Channel:
ADCR13 24
Knock Sensors used:
1
Spare 0-5V Channel:
ADCR14 7
Spare 0-5V Channel:
Knock 2
68
Lambda Sensors used:
1 (O2 # 1, wideband sensor required, original
O2 sensor not supported)
Spare Low Side Driver:
Low side 1
115
Idle Motor Type:
Pulse Width
Spare Low Side Driver:
Low side 2
37 & 57
Main Relay Control:
No (hardware controlled)
Spare Low Side Driver:
Low side 4
108
Crank Pickup Type:
Optical
Spare Low Side Driver:
Low side 8
114
Crank Teeth/Cycle:
24 (AEM trigger disc)
Spare Low Side Driver:
Low side 9
110
Cam Pickup Type:
Optical
Spare Low Side Driver:
Low side 12
105
** Cam Teeth/Cycle:
1 (AEM trigger disc)
Check Engine Light:
Low side 10
18
Transmissions Offered:
Manual/Automatic
Spare High Side Driver:
High side 1
11
Trans Supported:
Manual
Spare Switch Input:
Switch 1
35
Drive Options:
FWD, RWD
Spare Switch Input:
Switch 2
25
Supplied Connectors:
N/A
Spare Switch Input:
Switch 3
60
Spare Switch Input:
Switch 4
22
Spare Switch Input:
Switch 5
27
A/C Switch Input:
Switch 6
21
Wire View of AEM EMS
WARNING:
*All switch input pins must connect to ground; the switch should not provide 12V power to
the EMS because that will not be detected as on or off.