AEM 30-6611 Series 2 Plug & Play EMS - Manual (Page 5)

Page 5 of 13
1) Install AEMTuner software onto your PC
The latest version of the AEMTuner software can be downloaded from the AEMTuner
section of the AEM Performance Electronics forums. Series 2 units are not supported
by the older AEMPro tuning software.
2) Remove the Stock Engine Control Unit
a) Disconnect the negative terminal from battery
b) Access the stock Engine Control Unit (ECU). The location of the ECU on the Nissan
240SX vehicles is behind the kick-panel on the passenger side of the vehicle. All
other Nissan/Infiniti control units are located on the floor behind the center console
accessed from the passenger side.
c) Carefully disconnect the wiring harness from the ECU. Avoid excessive stress or
pulling on the wires, as this may damage the wiring harness. Some factory ECUs
use a bolt to retain the factory connectors, and it must be removed before the
harness can be disconnected. There may be more than one connector, and they
must all be removed without damage to work properly with the AEM ECU. Do not
cut any of the wires in the factory wiring harness to remove them.
d) Remove the fasteners securing the ECU to the car body, and set them aside. Do
not destroy or discard the factory ECU, as it can be reinstalled easily for street use
and troubleshooting.
3) Install the AEM Engine Management System
a) Plug the factory wiring harness into the AEM EMS and position it so the wires are
not pulled tight or stressed in any manner. Secure the EMS with the provided
Velcro fasteners.
b) Reconnect the negative battery terminal.
c) Plug the communications cable into the EMS and into your PC.
d) Turn the ignition on, but do not attempt to start the engine.
e) Connect the USB cable to the EMS and a computer. (Note: At the time these
instructions were written, new EMS units do not require USB drivers to be installed
on the PC. The EMS will automatically be detected as a human interface device
(HID).)
f) With the AEMTuner software open, select ECU>>Upload Calibration to upload the
startup calibration file (.cal) that most closely matches the vehicle’s configuration to
be tuned. Check the Notes section of the calibration for more info about the vehicle
it was configured for. These files can be found in the following folder:
C:\Program Files\AEM\AEMTuner\Calibrations\Nissan\
g) Set the throttle range: Select Wizards>>Set Throttle Range and follow the on-
screen instructions. When finished, check that the ‘Throttle’ channel never indicates
less than 0.2% or greater than 99.8%, this is considered a sensor error and may
cause some functions including idle feedback and acceleration fuel to operate
incorrectly.
4) Ready to begin tuning the vehicle.
a) Before starting the engine, verify that the fuel pump runs for a couple of seconds
when the key is turned on and there is sufficient pressure at the fuel rail.
If a MAP sensor is installed, check that the Engine Load indicates something near
atmospheric pressure (approximately 101kPa or 0 PSI at sea level) with the key on
and engine off. Press the throttle and verify that the ‘Throttle’ channel responds but
the Engine Load channel continues to measure atmospheric pressure correctly.