GrimmSpeed Mazdaspeed Electronic Boost Controller User Manual
Page 4
G
rimm
s
peed
4
4. Line up the left grommet hole with the existing front battery cover hole near the top of
the cover. The bracket grommets should be parallel with the top of the front battery cover.
5. Drill the left side mounting hole using a 1/4" drill bit.
6. Using provided Grimmspeed bolts and nuts, mount the solenoid on the battery cover.
Reinstall battery front cover and top cover.
See also other documents in the category GrimmSpeed For the car:
- 02-07 WRX Radiator Shroud (7 pages)
- 02-07 WRX Top Mount Intercooler (17 pages)
- 02-07 WRX/STi AOS (4 pages)
- 02-07 WRX/STi/Impreza Hood Struts (6 pages)
- 05-07 LGT Brake Master Cylinder Brace (5 pages)
- 08+ LGT AOS (9 pages)
- 38mm EWG (3 pages)
- 93-07 Impreza/WRX/STi Master Cylinder Brace (5 pages)
- Alternator Cover (4 pages)
- Antenna Delete Plate (4 pages)
- Battery Tie Down (3 pages)
- Brake Master Cylinder Brace (8 pages)
- BRZ//FR-S Intake (17 pages)
- BRZ/FR-S Pulley Cover (5 pages)
- Downpipe Install Guide (2 pages)
- Electronic Boost Controller Subaru (5 pages)
- Electronic Boost Controller EVO (6 pages)
- Electronic Boost Controller Hyundai (4 pages)
- Exhaust Manifold (2 pages)
- Gold Paint Guide (1 page)
- Heat Shield (3 pages)
- HiFlow CrossPipe (2 pages)
- Hood Struts (7 pages)
- Hyundai 160 Thermostat (2 pages)
- Hyundai Phenolic Spacer (3 pages)
- IWG Bracket (2 pages)
- License Plate (3 pages)
- License Plate Relocation (3 pages)
- Manual Boost Controller (4 pages)
- Strut Bar (4 pages)
- Subaru Lightweight Crank Pulley (14 pages)
- Subaru MAF Block Off (1 page)
- Subaru Reverse Downpipe Adapter (2 pages)
- Subaru Up pipe (3 pages)
- Top Mount Intercooler Splitter (2 pages)