GrimmSpeed Manual Boost Controller User Manual
Page 3
G
rimm
s
peed
3
4.
Remove hose from wastegate actuator.
5.
And remove the hose from the pressure side of the turbo.
6.
Connect the pressure source(compressor side of turbo, intake manifold, etc) to the inlet
on the GrimmSpeed manual boost controller using the supplied vacuum line. The inlet
side is at the bottom of the manual boost controller. See Fig. A. Tighten hose ends with
zip ties.
7.
If you need to reduce the size of the hose coming from the manual boost controller, utilize
the included reducer fittings.
See also other documents in the category GrimmSpeed For the car:
- 02-07 WRX Radiator Shroud (7 pages)
- 02-07 WRX Top Mount Intercooler (17 pages)
- 02-07 WRX/STi AOS (4 pages)
- 02-07 WRX/STi/Impreza Hood Struts (6 pages)
- 05-07 LGT Brake Master Cylinder Brace (5 pages)
- 08+ LGT AOS (9 pages)
- 38mm EWG (3 pages)
- 93-07 Impreza/WRX/STi Master Cylinder Brace (5 pages)
- Alternator Cover (4 pages)
- Antenna Delete Plate (4 pages)
- Battery Tie Down (3 pages)
- Brake Master Cylinder Brace (8 pages)
- BRZ//FR-S Intake (17 pages)
- BRZ/FR-S Pulley Cover (5 pages)
- Downpipe Install Guide (2 pages)
- Electronic Boost Controller Subaru (5 pages)
- Electronic Boost Controller EVO (6 pages)
- Electronic Boost Controller Hyundai (4 pages)
- Exhaust Manifold (2 pages)
- Gold Paint Guide (1 page)
- Heat Shield (3 pages)
- HiFlow CrossPipe (2 pages)
- Hood Struts (7 pages)
- Hyundai 160 Thermostat (2 pages)
- Hyundai Phenolic Spacer (3 pages)
- IWG Bracket (2 pages)
- License Plate (3 pages)
- License Plate Relocation (3 pages)
- Mazdaspeed Electronic Boost Controller (11 pages)
- Strut Bar (4 pages)
- Subaru Lightweight Crank Pulley (14 pages)
- Subaru MAF Block Off (1 page)
- Subaru Reverse Downpipe Adapter (2 pages)
- Subaru Up pipe (3 pages)
- Top Mount Intercooler Splitter (2 pages)