GrimmSpeed Manual Boost Controller - Manual (Page 2)

G
rimm
s
peed 2
B. Installation
1.
Attach supplied mounting bracket to manual boost controller using a 3mm hex wrench.
2.
Find a proper location in the engine bay to mount the manual boost controller. You can
either use the included bolt and nut (for through hole mounting), reuse a factory bolt, or
use a zip tie to attach the boost controller. Be sure to mount it away from anything that
would rub against it and make sure it is not mounted too close to an exhaust manifold or
other hot pipe.
3.
You will now remove all OEM boost controlling vacuum lines. (This includes removing any
restrictive pills). If the vehicle uses a boost control solenoid, we recommend leaving the
electrical connector plugged in to avoid check engine lights but you will still remove the
vacuum lines that are connected to it.