GrimmSpeed Alternator Cover - Manual (Page 2)

2. Now, remove your factory alternator cover if you still have it in place. This
will require a 10mm socket to remove the two fasteners securing it. Set the
nuts and the cover aside, you will not be needing them.
Figure 2: Remove 10mm nuts on each side
3. Next, remove the small rubber grommet from the driver’s side bracket. Yours
may pop right out, ours was a bit stubborn.
Figure 3: Remove Bushing
4. Rock on! Now, we’ll install the GrimmSpeed unit. Start my carefully placing
one of the larger washers onto the driver’s side as shown. Then, you’ll use the
parts shown in Figure 5 to assemble the driver’s side of the cover.
Remove Bushing
Remove 10mm nuts