Seat ball and socket – GrimmSpeed 02-07 WRX/STi/Impreza Hood Struts User Manual
Page 5
9. Lastly, lift your hood off of its prop and push the empty end of the strut down
onto the stainless ball stud. With a little bit of pressure, it should pop right
on. After it’s fully seated, push the small metal clip back into its original
position. Repeat on both sides.
Figure 9: Complete installation.
10. Now go ahead and install the GrimmSpeed branding tags in your desired
location! Simply removing the backing and apply with firm pressure.
Figure 13: Loosen lower hood hinge bolt.
Seat ball and socket
See also other documents in the category GrimmSpeed For the car:
- 02-07 WRX Radiator Shroud (7 pages)
- 02-07 WRX Top Mount Intercooler (17 pages)
- 02-07 WRX/STi AOS (4 pages)
- 05-07 LGT Brake Master Cylinder Brace (5 pages)
- 08+ LGT AOS (9 pages)
- 38mm EWG (3 pages)
- 93-07 Impreza/WRX/STi Master Cylinder Brace (5 pages)
- Alternator Cover (4 pages)
- Antenna Delete Plate (4 pages)
- Battery Tie Down (3 pages)
- Brake Master Cylinder Brace (8 pages)
- BRZ//FR-S Intake (17 pages)
- BRZ/FR-S Pulley Cover (5 pages)
- Downpipe Install Guide (2 pages)
- Electronic Boost Controller Subaru (5 pages)
- Electronic Boost Controller EVO (6 pages)
- Electronic Boost Controller Hyundai (4 pages)
- Exhaust Manifold (2 pages)
- Gold Paint Guide (1 page)
- Heat Shield (3 pages)
- HiFlow CrossPipe (2 pages)
- Hood Struts (7 pages)
- Hyundai 160 Thermostat (2 pages)
- Hyundai Phenolic Spacer (3 pages)
- IWG Bracket (2 pages)
- License Plate (3 pages)
- License Plate Relocation (3 pages)
- Manual Boost Controller (4 pages)
- Mazdaspeed Electronic Boost Controller (11 pages)
- Strut Bar (4 pages)
- Subaru Lightweight Crank Pulley (14 pages)
- Subaru MAF Block Off (1 page)
- Subaru Reverse Downpipe Adapter (2 pages)
- Subaru Up pipe (3 pages)
- Top Mount Intercooler Splitter (2 pages)