SkyTrak 10042 Operation Manual - Manual (Page 23)

Safety Practices
21 Model 10042 Rev. 11/03
DO NOT by-pass or disconnect any electrical or hydraulic circuits.
Consult the JLG Service Department or your local Sky Trak Distributor
if any circuit is malfunctioning.
DO check for frayed or cut seat belt webbing, damaged buckles or loose
mounting brackets. Replace immediately if required.
ALWAYS wear a seat belt when operating the vehicle.
DO check tire pressure on all four tires. Add air if required.
DO check the condition of all four rims. Check for bent flanges and/or
bead mounting areas.
DO check the parking brake/transmission de-clutch operation. Refer to
the test procedures on page 179. Repair immediately if required.
DO keep all non-skid surfaces clean and free of debris. Replace if worn,
damaged or missing.
DO check the condition of decals. Replace decals if missing, damaged
or illegible. The following pages show the proper location of the decals.
Equipment Considerations
WARNING:
DO NOT modify or alter (weld, drill, etc.) any
part of this vehicle without first consulting JLG. Modifications can
weaken the structure creating a hazard that can cause death or
serious personal injury.