SkyTrak 10042 Operation Manual - Manual (Page 177)

Test Procedures
175 Model 10042 Rev. 11/03
Test Procedures
To test the function of the Stabil-TRAK system, read the Stabil-TRAK
system test instructions on this page and follow steps 1 through 9 of the
Stabil-TRAK System Test Procedure.
Stabil-TRAK System Test Instructions
• Test the Stabil-TRAK system with the vehicle on a level surface.
• Remove any attachment from the quick attach before performing
the test.
• DO NOT extend the boom at any time during the test. Perform the
test with the boom fully retracted.
• DO NOT raise the boom above 60° for steps 3 through 6.
• DO NOT raise the boom above 45° for steps 7 through 9.
• Test vehicles with outriggers in the RAISED position.
• Follow steps 1 through 9 of the Stabil-TRAK system test procedure
exactly as written.
IMPORTANT! If the Stabil-TRAK light goes OFF and the front left tire lowers
to the ground at any time during steps 4 through 7, the test was not
performed properly or the Stabil-TRAK system is not functioning properly.
Carefully repeat the steps starting with step 1.
If the Stabil-TRAK light goes OFF and the front left tire lowers to the ground
consistently during steps 4 through 7, the Stabil-TRAK system is not
functioning properly and the test should be stopped immediately. Contact
your local Sky Trak Distributor immediately to repair the system.
Stabil-TRAK System Test
WARNING:
DO NOT operate this vehicle unless you are in
the seat with the seat belt fastened around you. Death or serious
personal injury could result if the belt is not securely fastened.