SkyTrak 10042 Operation Manual - Manual (Page 150)

148 Model 10042 Rev. 11/03
General Maintenance
A. Wheel End Oil Level
Check
1. Position the vehicle on level ground, move the vehicle forward or
backward enough to ensure that the lower edge of the wheel end
(1) fill/drain plug hole (2) is positioned horizontally (3).
2. Ground the carriage, place the travel select lever in (N) NEUTRAL,
move neutral lock lever to NEUTRAL LOCK position, engage the
parking brake switch and shut off the engine.
3. Clean the area around the wheel end fill/drain plug (2). Slowly
remove the plug. Check the oil level.
4. Add Universal Tractor Fluid to bring the oil level up and even with
the plug hole (2). See the above chart for approved fluids.
5. Clean and re-install the wheel end fill/drain plug (2).
11. Wheel End Oil
WARNING:
DO NOT perform service or maintenance on
this vehicle with the engine running. Contact with moving parts
can cause death or serious personal injury.
APPROVED UNIVERSAL TRACTOR FLUIDS
JOHN DEERE
FORD / NEW HOLLAND
MASSEY FERGUSON
CHEVRON
JDM J20C (HY-GARD)
ESN-M2C134-D (HYDRAULIC OIL134)
M-1141 (PERMATRAN III)
CHEVRON 1000 THF
OT0430
250
OH2710
OT0280
1
2
3