AKiTiO NT2 LAN - Manual (Page 8)

NT2 LAN Getting Started
Page 5
1.7 Before Use
1.7.1 Hard Drive Assembly
The drives can be installed at any position, there is no specific order required.
1. Remove the screw(s) at the bottom of the case and lift the front panel upward and away
from the housing to remove it.
2. Install the hard drives as illustrated below with the top of the drives, where the label is
located, facing each other. Push the drives lightly into place and then replace the front
panel. Mount the front panel and the drives by fastening the screws.
Note
Be careful not to damage any components, and do not force the drives into place. If the drives do
not easily slide into place and fit, please double check that they have been installed correctly. The
top of the drives, where the label is located, should face each other.
Important
While it is possible to start with only one hard drive, this is not recommended, as adding a second
drive at a later time will require re-initializing the system and doing so will erase all existing data on
the first drive.