ARB 3450110 - Manual (Page 7)

31 10 02 Page 7 of 16 3783013
17. Once holes have been drilled, fit captive nut
channels through lower aperture in vehicle
crossmember.
18. Secure using 10mm hardware and tighten
firmly making sure mounting system is hard
against vehicle crossmember.
NB. When step 19 is finished, slacken off
bolt tension to enable sideways movement if
needed when bar is fitted.
19. When front bolts are tighten, loosen off lower
bolts in chassis brackets. Using a 10mm drill
bit, drill out the most rearward hole in lower
chassis bracket being careful not to drill too
far into captive nut channel. When holes has
been drilled, realigned the rear hole with
rear nut in captive nut channel, and secure
using 10mm hardware, then lightly tighten
all bolts in lower chassis brackets.
MOUNTING SYSTEM MUST BE ABLE TO
BE MOVED SIDWAYS.