ARB 3450110 - Manual (Page 10)

31 10 02 Page 10 of 16 3783013
28. Drill 12mm holes under existing holes 25mm
lower down the same pitch as existing holes,
these will be the holes used to bolt to bar.
29. To fit winch into bar you must pack winch
up on a bench to enable you to lower bar
down on winch.
30. Line up top holes first and secure using 3/8”
hardware (1 ½”” x 3/8”bolts ) flat and spring
washers.
31. Place roller fairlead over lower holes and
again secure using 3/8” hardware ( 1 ¾”x
3/8” bolts ) flat and spring washers. When all
bolts are fitted tighten firmly.
NEW HOLES