ARB RD197 - Manual (Page 22)

3 Installing the Air Locker
20
10mm
3.6 Final Air Locker Assembly
3.6.1 A Assembly into IFS Clamshell Housing
 Place the Air Locker on a bench with the seal housing side on top.
 Assemble the non-pinion side of the clamshell onto the Air Locker
ensuring that the seal housing tube goes through the bulkhead
fitting, and that the seal housing bracket lines up with the ribs in the
clamshell (Figure 15.)
NOTE : Image shown is of a housing that has been saw-cut in
half. This has been done for illustration purposes so
that the seal housing tube profile and seal housing
bracket can be seen in position.
Figure 15.
 Turn the diff and housing over and assemble the pinion side of the
clamshell making sure you apply an appropriate gasket or sealant
between the two halves of the clamshell.
 Tighten all of the bolts to the torque specified in your vehicle
service manual. Make sure that both adjuster nuts are hand tight.