Philips 10000007 - Manual (Page 24)

ENGLISH
• 24 •
The machine is now ready to dispense coffee
and steam; for a description of machine
functions, see the specific sections.
5 MAKING COFFEE
Warning! While the brew unit is
operating it is forbidden to remove
the “Crema” filter holder by manually
turning it clockwise. Danger of burns!
• During this operation the temperature
ready light (5) may go on and off; this
is normal and not to be considered a
fault.
• Before using the machine, make sure
that the hot water/steam knob (7) is
closed and that there is a sufficient
amount of water in the tank.
• (Fig.4) - If the machine is off, turn it on
by pressing the ON/OFF switch (2); the
light (3) will go on.
• Wait until the temperature ready light (5)
goes on; now the machine is ready to
dispense coffee.
• (Fig.8) - Place the filter (13) inside the
“Crema” filter holder (12).
• (Fig.10) - Fit the “Crema” filter holder
into the brew unit (8) from below.
• (Fig.11) - Turn the filter holder from left
to right until it locks into place.
• Let go of the handle of the “Crema” filter
holder. An automatic system will now
cause the handle to shift slightly back
to the left. This serves to ensure that the
“Crema” filter will function perfectly.
• (Fig.13) - Preheat the “Crema” filter
holder by pressing the coffee switch
(4); water will start to come out of the
“Crema” filter holder (this operation
is only necessary for the first cup of
coffee).
• After allowing 50cc of water to flow out,
press the coffee switch (4) again to shut
off the flow of hot water.
• (Fig.15) - Remove the “Crema” filter
holder from the machine by turning it
from right to left and empty out any water
inside it.
• Thanks to the special “Crema” filter
holder (12) supplied with your machine,
you need not change the filter when you
switch between one and two cups of
coffee.
• (Fig.9) - Pour 1 or 2 level measures of
ground coffee in the filter, depending on
whether you want to make one or two
cups of coffee; wipe the edge of the filter
holder clean of any coffee grounds.
• (Fig.10) - Fit the “Crema” filter holder
into the brew unit (8) from below.
• (Fig.11) - Turn the filter holder from left
to right until it locks into place.
• (Fig.12) - Place 1 or 2 preheated cups
beneath the “Crema” filter; make sure
that you position them properly under
the coffee outlets.
• (Fig.13) - Press the coffee button (4).
• When you have dispensed the desired
amount of coffee, press the coffee but-
ton (4) again to stop flow and remove the
cups containing the coffee (Fig.14).
• (Fig.15) - After making coffee, wait
a few seconds, remove the “Crema”
filter holder and empty out the used
grounds.
Making coffee