Philips 10000007 - Manual (Page 23)

ENGLISH
• 23 •
4 INSTALLATION
For your own safety and the safety
of others, you must strictly comply
with the “Safety Rules” described in
section 3.
4.1 Packaging
The original packaging was designed
and made to protect the machine during
shipping. We recommend keeping it for
future transport purposes.
4.2 Installation precautions
Before installing the machine, make sure
to follow these safety precautions:
• put the machine in a safe place;
• make sure that children are not allowed
to play with the machine;
• avoid placing the machine on very hot
surfaces or near open flames.
Now the coffee machine is ready to be
connected to the mains power supply.
4.3 Mains connection
Electricity can be dangerous!
Therefore, always strictly abide
by the safety rules.
Never use defective cords!
Defective cords and plugs must be
immediately replaced by an Authorised
Service Centre.
The coffee machine must be plugged into
a suitable electric socket.
The voltage of the appliance is factory set.
Check that the mains voltage matches the
rating specified on the identification plate
on the bottom of the appliance.
• Before plugging in the machine, make
sure the ON/OFF switch is not pres-
sed (2).
• Insert the plug into a suitable electric
socket.
4.4 Filling the water tank
• (Fig.1) - Remove the water tank (1). An
automatic device will raise the water
intake tube.
• (Fig.2) - Rinse out the tank and fill it with
fresh drinking water, taking care not to
overfill.
• (Fig.3) - Fit the tank back in place; press
firmly to activate the automatic device,
which will immerse the intake tube in the
water.
Always fill the tank with fresh, still
drinking water.
Hot water and/or other liquids may
damage the tank. Always make sure
that there is sufficient water in the tank
before starting the machine.
4.5 Loading the circuit
Before starting the machine, if it has been
inoperative for a long time and all the
water has been used up, you must reload
the circuit.
• (Fig.4) - Press the ON/OFF switch (2).
The light (3) will go on.
• (Fig.5) - Place a container beneath the
steam tube. Turn the “hot water/steam”
knob (7) counterclockwise to open.
• (Fig.6) - Press the coffee switch (4).
• Wait until a steady stream of water flows
from the steam tube (“pannarello”).
• Press the coffee switch (4) again. Turn the
“hot water/steam” knob (7) clockwise
to shut off flow (Fig.7). Remove the
container.
Installation