Philips TS1000 - Manual (Page 66)

64 Chapter 5—Settings
Second Setup panel
Setting What it does How to adjust it
Light Sensor Shows the current level of light in the room (ambient light).
Set Level Sets the light level at
which the light sensor
turns the backlight on. Tap Level, then use the Left (-)
and Right (+) buttons to
increase or decrease the
sensitivity.
To set the level relative to the
current lighting, first tap Set; the
Level indicator shows the
current light level. Then use the
Left and Right buttons to
increase or decrease the
sensitivity.
Mode Menu Hides or shows the
Mode button
on
the display. Hiding the
Mode button prevents
unwanted changes to
stored commands.
Tap the Mode Menu button
once.
Touchscreen
Beep Adjusts or turns off the
touchscreen beep. Tap repeatedly to cycle through
four volume levels, including
off.
Button Beep Adjusts or turns off the
beep of the direct-
access, Left, and Right
buttons. Tap repeatedly to cycle through
four volume levels, including
off.
Calibrate Calibrates the touchscreen.
See Chapter 6, “Troubleshooting.” You won’t normally
need to adjust the calibration.
Revert Reverts to the factory default configuration. All customization
and programming is lost.
See Chapter 6, “Troubleshooting.” You won’t normally
need to use the Revert button.