Philips TS1000 - Manual (Page 20)

18 Chapter 2—Using the remote control
Using the remote control
to control your equipment
NOTE The remote control is preprogrammed to work with popular
components made by Philips, Marantz, and certain other companies. If the
remote control doesn’t operate your components, you will need to teach it; for
instructions, see “Learning commands from other remote controls (Learn
mode)” on page 30. However, if a dealer or installer has programmed the remote
control for you, it should operate all your components.
Home
When you first tap the touchscreen, Home is diplayed. Here you’ll find a
button for each of the devices that the remote control is set up to operate.
Tap one of the buttons to choose a device.
NOTE If your components are connected to a preamplifier, receiver, or similar
device, choosing a device from Home may automatically switch the input source
to the chosen device. You can control this behavior; for more information, see
“To program an item on the Device menu” on page 34.
GOING BACK HOME
The purpose of Home is to make navigating easy. The device buttons in Home
are set up for you automatically when you add devices to your system or remove
them. You can go back home at any time by pressing the Home button
.
Tap a device ... ... the remote control displays
a control panel for the device.
Home