Philips TS1000 - Manual (Page 59)

Editing macros 57
To view the commands in a macro
To view the commands in a macro while in Use mode:
1 Display the macro panel that contains the macro.
2 Press and hold the Left button, labeled OPEN . While holding it down, tap
the macro you want to open.
Use the scroll buttons and to view the entire macro.
To execute (play) the macro, press the Right button. When you’re ready to close
the macro, press the Left button.
Editing macros
Once you have recorded a macro, you can add, remove, or change the order of
commands in the macro. You can also add delays.
NOTE You should add a delay after turning on a device before sending more
commands to the device. Some devices recognize infrared commands only after
they have had time to “warm up.”
To edit a previously recorded macro
1 Display the macro panel that contains the macro.
2 Switch the remote control to Record mode: Tap the Mode button to
display the Mode menu. Then, tap .
3 Tap the macro you want to edit.
The contents of the macro appear on the display.
Move the selected
command up or
down in the list.
Scroll to see more
commands in this
macro.
Tap a command
to select it.
Add a delay.
Delete the selected
command.