Brocade Communications Systems Brocade EZSwitchSetup 5100 - Manual (Page 15)

EZSwitchSetup Administrator’s Guide 3
53-1002157-01
Supported switches
1
FIGURE 2 Configuring Internet Explorer
Supported switches
You can use EZSwitchSetup with the switches listed in “Supported hardware and software” on
page viii.
Your switch must meet the following requirements:
• It must be connected to an Ethernet LAN that is accessible by the host. If it is not, the system
issues the message “Page not Found.”
• It must have licensed FC ports. If the switch has no licensed FC ports, you must first install a
POD license and then enable the affected ports. For more information, refer to the section
“Add port license” on page 35
• It must be in a single-switch fabric. If your switch connects to another switch (if there is an
E_Port on the switch), you cannot manage the switch using EZSwitchSetup until you
disconnect the switch connection.
NOTE
If there is an E_Port on the switch and if there is a zone conflict, then the fabric is segmented;
in this case, the switch is in a fabric by itself and EZSwitchSetup treats it as a single-switch
fabric.
You cannot use EZSwitchSetup to manage a switch that has any of the following features enabled:
• Virtual Fabrics with non-default logical switches
• Access Gateway
• User-defined Admin Domains
Configure your browser to
check for newer versions of
stored pages on every visit to
the page.