Philips Wireless PC-TV-Verbindung - Manual (Page 12)

5. Problem solving
If a fault occurs, first check the points listed below. If you are unable to
remedy a problem by following these hints, contact the helpline
(see ‘Need help?’) or consult your dealer.
Never try to open the set yourself as this will void the guarantee.
First, check all cables to ensure that they are connected correctly.
Problem Solution
No picture on TV • Turn on the PC and start playing a video file. Make sure the TV-Out output
of the video card is activated and a video signal is present.
Refer to the Instructions For Use of the video card on how to activate the
TV-Out output of the video card.
• In case you have a portable TV you can check if a TV-out signal is present
on your video card by transferring the TV to the PC and connect the
TV-out directly to the TV.
• Make sure both units are turned on
(both green power lights (1 and 11) are lit).
• Select the correct EXT or AV channel on TV.
Refer to the Instructions For Use of the TV.
• Select the same channel on the receiver and transmitter units,
using CHANNEL switches 6 and 16.
Bad picture/ • Move the receiver unit around on the surface it is positioned on,
sound quality centimetre by centimetre until you get good picture and sound quality.
on TV • Carry out the same procedure for the transmitter unit.
• Change both units to another frequency channel, using CHANNEL switches
6 and 16.
Make sure that both units use the same frequency channel.
• Reduce the distance between the transmitter and receiver units
(less than 30 metres).
ENGLISH 11
SBC_LM1000.qxd 04-02-2004 11:21 Pagina 11