Brother MFC-8510DN - Manual (Page 118)

110
Improving the print quality
B
If you have a print quality problem, print a test page first (Menu, 4, 2, 3). If the printout looks good,
the problem is probably not the machine. Check the interface cable connections and try printing
a different document. If the printout or test page printed from the machine has a quality problem,
check the following steps first. And then, if you still have a print quality problem, check the chart
below and follow the recommendations.
Note
Using non-Brother supplies may affect the print quality, hardware performance, and machine
reliability.
a
To get the best print quality, we suggest using the recommended paper. Check that you use
paper that meets our specifications. (See Acceptable paper and other print media
uu
page 18.)
b
Check that the drum unit and toner cartridge are installed correctly.
Examples of poor print
quality Recommendation
Faint
 Take out the drum unit and toner cartridge assembly. Hold the
assembly level with both hands and gently shake it from side to side
several times to spread the toner evenly inside the cartridge.
 If the LCD shows Replace Toner, put in a new toner cartridge.
SeeReplacing the toner cartridge uu page 64.
 Check the machine’s environment. Conditions such as humidity, high
temperatures, and so on, may cause this print fault.
See Product Safety Guide: Choosing a location.
 If the whole page is too light, Toner Save may be turned on. Turn
off Toner Save in the machine's menu settings or
Toner Save Mode in the Printer Properties of the driver.
See Advanced User's Guide: Toner Save.
See Software User's Guide: Printing (for Windows
®
).
See Software User's Guide: Printing and Faxing (for Macintosh).
 Clean the corona wire of the drum unit.
See Cleaning the corona wire uu page 69.
 Put in a new toner cartridge.
See Replacing the toner cartridge uu page 64.
 Put in a new drum unit.
See Replacing the drum unit uu page 71.
ABCDEFGH
abcdefghijk
A B C D
a b c d e
0 1 2 3 4
CDEF
defg
B C
b c d
2 3