BT Hub Phone 1010 - Manual (Page 11)

Hub Phone 1010 – Edition 3 – 13.04.06 – 7451
Handset Registered is displayed. Validate the base
association by pressing and the handset goes back to
idle.
If the handset does not locate the base, it goes back to
idle mode. Try again by changing the base number and
make sure there are no interferences in the environment.
If the handset emits a double beep, it means that the
PIN code is wrong or the base has already 5 subscribed
handsets.
The handset searches for a link with the hub and then
the display goes into standby mode:
Getting started 11
When a handset is associated with
a base, a number is attributed to
the handset by the base. This
number is displayed on the handset
after the name and must be used
for internal calls.
Hub Phone 1010 [3]DkBlue 13/4/06 5:44 pm Page 11