Brother HL-3450CN - Manual (Page 175)

CHAPTER 6 OPTIONS
6-19
In general, the DIMM must have the following specifications:
Type: 100 pin and 32 bit output
CAS Latency: 2
Clock Frequency: 66MHz or more
Capacity: 16,32, 64 or 128 Mbyte
Height: 46mm (1.8 inches) or less
Parity: NONE
Dram Type: 64M bit SDRAM 4 Bank SDRAM can be used.
Note
•
There might be some DIMMs that will not work with this printer.
• For more information consult the dealer where you purchased the
printer.
•
For the latest information: http://solutions.brother.com
I I I
N N N S S S T T T A A A L L L L L L I I I N N N G G G D D D I I I M M M M M M
S S S
1. Turn off the printer, and then unplug the power cord from the AC outlet.
Note
Be sure to turn off the power to the printer before installing or removing the
DIMMs.