Brother MFC 990cw User Manual
Page 165
Troubleshooting and Routine Maintenance
153
B
d
Turn the green knob on the protective
yellow cap clockwise until it clicks to
release the vacuum seal, then remove
the cap (1).
e
Each colour has its own correct position.
Insert the ink cartridge in the direction of
the arrow on the label.
f
Gently push the ink cartridge in until it
clicks, and then close the ink cartridge
cover.
g
The machine will automatically reset the
ink dot counter.
Note
• If you replaced an ink cartridge, the LCD
may ask you to verify that it was a brand
new one (for example, Did You Change
Black). For each new cartridge you
installed, press Yes to automatically reset
the ink dot counter for that colour. If the ink
cartridge you installed is not a brand new
one, be sure to press No.
• If the LCD shows No Cartridge or
Cannot Detect after you install the ink
cartridges, check that the ink cartridges
are installed correctly.
WARNING
If ink gets in your eyes, wash them out with
water at once and call a doctor if you are
concerned.
1